Preparation: paste or fix the drawing paper containing area on a drawing board. Place the roller at the positioning which will make a right with the main body.
By tracing the outline of the fig. if any inconvenient movement of the roller is found then position of the roller is adjusted.
Procedure
- Press- NO key to switch on the power supply.
- Select the unit by using 2 keys of Unit- 1 and unit – 2.
- Put a mark like ‘P’ on the outer periphery of the fig. to use it as a starting point.
- Press START key, the buzzer sound lightly. Confirm that display shows 0 then trace the fig. by lens clockwise the circumference of the fig and close on starting point. The area of fig. will be displayed on display panel.
- Bigger areas are divided into two or three parts of convenience.
- By the use of MEMO and AVER, the same area can be a measured number of times and its meaning can be obtained for increase measuring accuracy.
